Fabricated Components for Wet Jig System

pdblowers has assisted one of our long time customers with yet another large scale custom fabrication project, building many of the components for a wet jig system.

Wet Jig Working Principle

A wet jig system uses gravity and pulsation to separate materials in mining operations.

Material is added at the top of the jig where it lands on a bed and screen. Water pulses up and down, agitating the material.  The heavier particles pass through the screen and settle down as they concentrate. The water current carries the lighter particles out of the tank through a separate exit.

Custom Fabricated Air Tank Receiver for Wet Jig
Close Up - Air Tank Receiver for Wet Jig
Custom Fabricated Feed Chute for Wet Jig
Custom Fabricated Hutch for Wet Jig
Custom Fabricated Screen Housing for Wet Jig
Custom Fabricated Screen Housing for Wet Jig
Custom Fabricated Inlet and Outlet Box for Wet Jig
Custom Fabricated Overflow Box for Wet Jig
Custom Fabricated Components for Wet Jig
Related Projects

Dewatering Bucket Wheels

In our 50,000 square foot manufacturing facility, large scale material handling is common.  Gantries, hoists, and several large bridge cranes allow movement of even the largest fabricated components.  So when one of our customers needed custom fabricated components for a...
Read More

Custom Fabrication of Large Components

While pressure and vacuum systems are our primary focus, our production facility has all of the tools and expertise to fabricate large custom parts for our customers.  In this project we built VLR Turning Vanes and a Fine Bubble Effluent...
Read More