Product Description

Not a stock item – Must be purchased in multiples of four

Solberg Wire Mesh 334S Filter Element
Element Rating: 800 SCFM
Surface Area ft2: 34
Inner Diameter: 4 3/4″
Outer Diameter: 7 7/8″
Height: 14 1/2″
Endcap: Molded plastisol
Filtration: Epoxy Coated Wire Mesh Pleated Media
Temp (continuous): min -15°F (-26°C) max 220°F (104°C)
Filter change out differential: 15-20″ H2O over initial Δ P

Solberg Wire Mesh Filter Elements

  • Less maintenance
  • More durable than paper media
  • Moisture resistant
  • Handles hot air and oil mist from unload cycle of reciprocating/piston compressor

Cleaning Solberg Filter Elements

Solberg filter elements should be cleaned or replaced once the pressure drop reaches 10 to 15-inches water column (250 – 380mm WC) above the initial pressure drop of the installation. Please note that the overall performance of a filter element is altered once cleaned; the initial pressure drop after cleaning will be greater than the original, clean pressure drop of the element. After each subsequent cleaning, the initial pressure drop will continue to increase. Under all circumstances, the initial pressure drop of the element needs to be maintained at less than 15-inches water column (380mm WC). Cleaned elements that exceed 15-inches water column (380mm WC) at start-up should be replaced with new elements.

  • Paper Element: The paper element may be lightly blown with low pressure air. It is disposable and in most cases should be replaced with a new element.
  • Polyester Element: The polyester element may be washed in warm soapy water, vacuumed, gently blown out or replaced. Use a mild detergent like Dawn liquid soap.  The element should be completely dry before reinstallation. The element should be replaced after a maximum of three cleanings.
  • Polyurethane Prefilter: The prefilter may be washed as a sponge or replaced to give the element a longer service life.
  • Epoxy Coated Wire Mesh and Stainless Steel Wire Mesh Elements: Cleaning instructions similar to polyester, except mild solvents may be used.

334S Wire Mesh Filter Element

BOM Number: 334S Categories: ,

Not a stock item – Must be purchased in multiples of four

Shipping Weight: 8 lbs
Shipping Dimensions: 8 × 8 × 14.5 in
Filter Outside Diameter:

7.875"

Filter Height:

14.5"

Filter Inside Diameter:

4.75"

Media Type:

Wire

Manufacturer:

Solberg Manufacturing

Contact us for more info